Kia Sorento: Drive Plate Removal and Installation - Cylinder Block - Engine Mechanical SystemKia Sorento: Drive Plate Removal and Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cylinder Block / Drive Plate Removal and Installation

1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate (A) and the adapter plate (B).

Tightening torque :
117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft)

  
    1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap 9. Ladd...
    1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. (Refe...
    See also:

    Power Seat Motor Repair Procedures
    Removal Reclining Motor 1. Remove the front seat back cover assembly. (Refer to Body - "Front Seat Back Cover") ...

    SRS Control Module (SRSCM) Installation
    1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

    Cylinder Head Cover Repair procedures
    Removal ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0793