Kia Sorento: Evaporator Temperature Sensor Replacement - Air conditioning System - Heating,Ventilation And Air ConditioningKia Sorento: Evaporator Temperature Sensor Replacement

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Evaporator Temperature Sensor Replacement

1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater and blower assembly.
(Refer to Heater - "Heater Unit")
3.
Remove the heater unit lower case (A) after loosening the mounting screws.

4.
Remove the evaporator sensor (A).

5.
Install in the reverse order of removal.
Evaporator Temperature Sensor Inspection
1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure resistance between ...
In-car Sensor (DATC only) Description
An in-car air temperature sensor is located in the crash pad lower panel. The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance val...
See also:

4WD ECU Removal
1. Prior to replacing the 4WD ECU, check the 4WD ECU's clutch learing with the GDS tool. (Refer to 4WD Control System - "Repair procedures") ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P (Park) po ...

Heater & A/C Control Unit (Manual) Component
Connector Pin Function Connector Pin No Function Connector Pin No Function A 1 Ground B 18 IG ...

Copyright © xm.ksmanual.com 2014-2026 - 0.04