Kia Sorento: Front Washer Motor Inspection

Front and Rear Washer Motor

With the washer motor connected to the reservoir tank, fill the reservoir tank with water.

Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.

2.	Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively.

3.	Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles.

4.	If they are abnormal, replace the washer motor. [Front & Rear washer] 1. Windshield washer (+) 2. Ground 3. Rear washer (+)

Washer Fluid Level Sensor Switch

1.	Disconnect the negative(-) battery terminal.

2.	Drain the washer fluid less than 650 cc.

3.	Check for continuity between the No. 1 and No.2 terminal in each float position. There should be continuity when the float is down. There should be no continuity when the float is up.

4.	If the continuity is not as specified, replace the washer fluid level switch

Speed Operation Check 1. Remove the connector (A) from the wiper motor. 2. Attach the positive (+) lead from the battery to terminal 2 ...

- When servicing the washer pump, be careful not to damage the washer pump seal. - ...

Manuals list