Kia Optima Manuals

Kia Sorento: Installation - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel SystemKia Sorento: Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Rail Pressure Sensor Installation: 18.0 ~ 22.0 N.m (1.8 ~ 2.2 kgf.m, 13.3 ~ 16.2 lb-ft)
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to the Fu...
Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine con...
See also:

Front seat adjustment - power (if equipped)
The front seat can be adjusted by using the control switches located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so you can easily control the steerin ...

Components Location
1. PCV Valve 2. Canister 3. Purge Control Solenoid Valve (PCSV) 4. Fuel Tank Pressure Sensor (FTPS) 5. Canister Close Valve (CCV) 6. Fuel Level Sender (FLS) 7. Fuel Ta ...

Side curtain: (if equipped)
To use the side curtain: Lift the integrated window curtain upward using the de ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026