Kia Optima Manuals

Kia Sorento: Removal - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel SystemKia Sorento: Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
  
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.
Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...
Installation
   • Install the component with the specified torques. • Note that in...
See also:

Drive Plate Removal and Installation
1. Remove the automatic transaxle . (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate ( ...

Circuit Diagram
Circuit Diagram (2) Circuit Diagram (3) ...

Wipers and washers
The advanced wipers and washers efficiently clear away foreign substances and debris from both the windshield and rear window to ensure uncompromised visibility in all weather conditions. ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026