Kia Sorento: Accelerator Position Sensor (APS)
Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine control system, so it consists of the
two sensors which adapt individual sensor power and ground line. The second
sensor monitors the first sensor and its output voltage is half of the first
one. If the ratio of the sensor 1 and 2 is out of the range (approximately 1/2),
the diagnostic system judges that it is abnormal.
...
Installation
Accelerator
Position
Output Voltage (V)
APS1
APS2
C.T
0.7 ~ 0.8
0.275 ~ 0.475
W.O.T
3.8 ~ 4.4
1.75 ~ 2.35...
Specification
See also:
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the ...
Ignition Coil Circuit Diagram
...
Engine start/stop button
Illuminated Engine Start/Stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the do ...
Copyright © xm.ksmanual.com 2014-2026 - 0.031