Kia Sorento: Oil hydraulic Motor(Actuator) Installation

Kia Sorento (XM, 2011-2015) Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Oil hydraulic Motor(Actuator) Installation

1.	Before installation, wipe the surface with a clean cloth.

Check the O-rings (A) of the new hydraulic motor (actuators).

•	You have to prevent any dust from entering inside hydraulic motors (actuators) and housing.

Tighten the bolts after install the hydraulic motor (actuators).

•	When installing, motor connector has to toward in the direction of outside of the Coupling.

Tightening torque:

8.8 ~ 10.8 N.m (0.9 ~ 1.1 kgf.m, 6.5 ~ 8.0 lb-ft)

•	When installing, oil can be reflux by the pressure in air breather hole.

•	Change direction in the direction of the arrow and lay on the floor as shown in the illustration. ※ The reflux oil will flow to the bottom.

•	You have to prevent additional backflow in according to order as shown in the illustration.

4.	Wipe the flowed oil to around the surface with a clean cloth.

5.	Install the coupling assembly. (Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling")

Oil hydraulic Motor(Actuator) Removal

1. Remove the coupling assembly. (Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling") 2. Keep going perpendic...

Pressure Sensor Description

The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque val...

Kia Sorento: Oil hydraulic Motor(Actuator) Installation

Oil hydraulic Motor(Actuator) Removal

Pressure Sensor Description

See also:

Manuals list