Kia Sorento: Oil hydraulic Motor(Actuator) Removal - Coupling Assembly - 4 Wheel Drive (4WD) SystemKia Sorento: Oil hydraulic Motor(Actuator) Removal

Kia Sorento (XM, 2011-2015) Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Oil hydraulic Motor(Actuator) Removal

1.
Remove the coupling assembly.
(Refer to Coupling Assembly - "Direct Electro Hydraulic Actuator Coupling")
2.
Keep going perpendicular state after remove the coupling assembly.
  
While removing the hydraulic motor from the coulping assembly, make sure that the hydraulic motor keeps being vertical to the level of work table or ground as shown in the image below not to allow the coupling oil to spill out. If the coupling oil spilled out of the hydraulic motor or the coupling assembly, replace the coupling assembly with new one. (We do not recommend to add or change the coupling oil because the coupling oil's spec and fill ratio greatly effect the performance and durability of the coupling assembly.)

3.
Remove the hydraulic motor (A) after loosening bolts with hex wrench.
  
       If you have trouble code related to the oil hydraulic motor (actuator), check oil hydraulic motor (actuator) according to the inspection process. ...
    1. Before installation, wipe the surface with a clean cloth. 2. Check the O-rings (A) of the new hydraulic motor (actuators). ...
    See also:

    General Inspection
    After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

    Piston and Connecting Rod Components
    1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Connecting rod lower bearing 7. Connecting rod bearing cap ...

    Transaxle Oil Temperature Sensor Installation
    1. Install in the reverse order of removal.    ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0641