Kia Sorento: Operation - Power Windows - Body Electrical SystemKia Sorento: Operation

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Power Windows / Operation

Function Of Safety Power Window
When all door (Front, Rear) power window auto-up switch is operated, safety function is activated.
1.
Safety function condition
When detect the force of 100N during the window rising, window is reversed.
2.
Length of window reversing (except holding the auto-up switch)
A.
When detect the jamming during the 4mm ~ 250mm from top of the door.
→ Window is reversed until 300mm from top of the door.

B.
When detect the jamming over the 250mm from top of the door.
→ Window is reversed until 50mm from jamming position.
→ Window is reversed 50mm or bottom position in case of 50mm reversing distance.

C.
When detect the jamming over 300mm from top of the door.
→ Window stops at reverse point.
3.
Length of window reversing (holding the auto-up switch)
A.
When detect the jamming during holding the auto-up switch.
→ Window is reversed until 25mm from jamming position.
B.
Auto-up function is not available during the 5 seconds from above condition.
→ When holding the auto-up switch, window is operated as a manual-up function. (Safety function is not activated.)
C.
When detect the jamming during holding the auto-up switch again.
→ Window is reversed until 25mm from jamming position.
D.
When holding the auto-up switch after 5 seconds from above condition.
→ Window is reverse until 25mm from jamming position.

4.
Safety function is not available area
Safety function is not available during the 4mm from top of the door.
Normalization (Teaching)
After power on reset or error detection, the motor has to be nomalized at the fully closed position.
How to be nomalized:
    Component Location
    1. Driver power window main switch 2. Passenger window switch 3. Front window motor 4. Rear window motor 5. Rear window switch...
    Power Window Motor Inspection
    Front Power Window Motor 1. Remove (-) negative battery terminal. 2. Remove the front door trim. (Refer to Body - "Front door"...
    See also:

    Side Airbag (SAB) Module Removal
       The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. ...

    Alternator Removal
    1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove th ...

    Circuit Diagram
    ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.0485