Kia Sorento: Radiator Inspection - Cooling System - Engine Mechanical SystemKia Sorento: Radiator Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Cooling System / Radiator Inspection

Radiator Cap Testing

1.
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester.

2.
Apply a pressure of 79.4 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 11.5 ~ 17.78 psi).
3.
Check for a drop in pressure.
4.
If the pressure drops, replace the cap.

Radiator Leakage Test

1.
Wait until engine is cool, then carefully remove the radiator cap and fill the radiator with engine coolant, then install it on the pressure tester.

2.
Apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 13.51 ~ 17.78 psi).
3.
Inspect for engine coolant leaks and a drop in pressure.
4.
Remove the tester and reinstall the radiator cap.
  
Check for engine oil in coolant and/or coolant in engine oil.
Radiator Removal and Installation
1. Disconnect the battery terminals. 2. Remove the air cleaner assembly. (Refer to Intake And Exhaust System - "Air Cleaner") ...
Cooling Fan Components
1. Upper air guard 2. Cooling fan control module 3. Cooling fan shroud 4. Fan motor 5. Cooling fan...
See also:

Steering Column and Shaft Disassembly
Universal joint assembly 1. Loosen the bolt (A) and then disconnect the universal joint assembly from the steering column assembly. Tightenin ...

Engine Coolant temperature sensor (ECTS) Removal and Installation
Removal Engine Coolant Temperature Sensor (ECTS) - ITM 1. Remove the air cleaner assembly. (R ...

Injector Removal and Installation
Removal 1. Remove the injector. (Refer to Fuel Delivery System - "Delivery Pipe") ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0519