Kia Sorento: Rear Wiper Motor Inspection - Rear Wiper/Washer - Body Electrical SystemKia Sorento: Rear Wiper Motor Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Inspection

Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
1. IGN +
2. Parking
3. Switch
4. Ground

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 3.
3.
Connect terminals 2 and 3.
4.
Connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 4.
5.
Check that the motor stops running at the off position.

Component Location
1. Rear wiper arm & blade 2. Tailgate glass hole 3. Grommet 4. Rear wiper arm nut 5. Rear wiper motor assembly 6. Head cap 7. Rear wiper motor bolt...
Rear Wiper Motor Removal
1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B). ...
See also:

Panorama Sunroof Motor Inspection
1. Close the panorama sunroof glass and blind completely (Full close position). 2. Disconnect the negative (-) battery terminal. ...

Head Lamps Component (1)
1. Head lamp assembly 2. Head lamp high beam bulb 3. Head lamp low beam bulb 4. Dust cap 5. Turn signal lamp socket & bulb ...

Special Service Tools
Tools (Number and name) Illustration Use 09200-3N000 Engine support fixture(Beam) Removal and installation of the transaxle. Except lo ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0326