Kia Sorento: Removal - Accelerator Position Sensor (APS) - Engine Control System - Engine Control / Fuel SystemKia Sorento: Removal

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) / Removal

1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (C), the bolt (B) and then remove the accelerator pedal module.

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the ...
Installation
1. Install in the reverse order of removal. Accelerator pedal module installation nut: 16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft) ...
See also:

Timing Chain Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fu ...

Curtain Airbag (CAB) On Vehicle Inspection. Curtain Airbag (CAB) Troubleshooting
Curtain Airbag (CAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The center side ...

MDPS System Repair procedures
Inspection 1. MDPS power pack assembly failure can be quickly diagnosed using the vehicle diagnostic system (KDS). ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0524