Kia Sorento: Wheel Hub nut tightening sequence - Tires/Wheels - Suspension SystemKia Sorento: Wheel Hub nut tightening sequence

Kia Sorento (XM, 2011-2015) Service Manual / Suspension System / Tires/Wheels / Wheel Hub nut tightening sequence

Tighten the hub nuts as follows.

Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)

  
When using an impact gun, final tightening torque should be checked using a torque wrench.
Run out inspection
1.
Jack up the vehicle.
2.
Measure the wheel Run-out by using a dial indicator as illustration below.
Run-out
Aluminum
Radial mm(in.)
Below 0.3(0.0118)
Lateral mm(in.)
Below 0.3(0.0118)

3.
If measured value exceeds the standard value, replace the wheel.

Tire Installation
1. Apply tire soap or lubrication to the top and bottom tire beads. 2. To fit the bottom bead, position the valve at the 5 o...
Front wheel alignment
   When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always position the vehicle on...
See also:

Components
1. Steering column shaft 2. ECU 3. Motor 4. Steering gear box ...

Trouble Symptom Charts
Trouble Symptom 1 Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward "Surgin ...

Lane Departure Warning System (LDWS) Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the LDWS unit cover (A). 3. Remove the LDWS ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0474