Kia Sorento: Battery Vehicle parasitic current inspection - Charging System - Engine Electrical SystemKia Sorento: Battery Vehicle parasitic current inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Electrical System / Charging System / Battery Vehicle parasitic current inspection

1.
Turn the all electric devices OFF, and then turn the ignition switch OFF.
2.
Close all doors except the engine hood, and then lock all doors.
(1)
Disconnect the hood switch connector.
(2)
Close the trunk lid.
(3)
Close the doors or remove the door switches.
3.
Wait a few minutes until the vehicle
    Battery Installation
    1. Install in the reverse order of removal. Battery (-)terminal installation nut: 4.0 ~ 6.0 N.m (0.4 ~ 0.6 kgf.m, 3.0 ~ 4.4 lb-ft) ...
    Battery Cleaning
    1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...
    See also:

    Transaxle Control Module (TCM) On Vehicle Inspection
    Inspection 1. TCM ground circuit test : Measure the resistance between TCM and chassis ground. (Inspect the terminal connec ...

    Heater & A/C Control Unit (Manual) Replacement
    1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the center fascia panel (A). ...

    Rear Upper Arm Removal
    1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

    Copyright © xm.ksmanual.com 2014-2026 - 0.051