Kia Sorento: Blind Spot Detection Unit Removal - Blind Spot Detection System - Body Electrical SystemKia Sorento: Blind Spot Detection Unit Removal

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Blind Spot Detection System / Blind Spot Detection Unit Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear bumper.
(Refer to Body - "Rear Bumper")
3.
Remove the BSD unit (A) after loosening the mounting screws.

  
Take care not to separate the bracket from rear bumper when removing the BSD sensor.
Blind Spot Detection Unit Circuit Diagram
...
Blind Spot Detection Unit Installation
1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery terminal. ...
See also:

Transaxle Control Module (TCM) Removal
   When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

External Amplifier Components
Connector Pin Information No. Connector A (26 pin) Connector B (16 pin) Connector C (12 pin) 1 Battery + Right surround speaker + ...

Driving with a trailer
Towing a trailer requires a certain amount of experience. Before setting out for the open road, you must get to know your trailer. Acquaint yourself with the feel of handling and braking with the ad ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0421