Kia Optima Manuals

Kia Sorento: Compression Pressure Inspection - Engine Mechanical SystemKia Sorento: Compression Pressure Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Engine Mechanical System / Compression Pressure Inspection

  
If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
2.
Disconnect the injector extension connector (A) and ignition coil connectors (B).
3.
Remove ignition coils (A).
4.
Remove spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
5.
Check cylinder compression pressure.
(1)
Insert a compression gauge into the spark plug hole.
(2)
Fully open the throttle.
(3)
While cranking the engine, measure the compression pressure.
  
Always use a fully charged battery to obtain engine speed of 200 rpm or more.
(4)
Repeat steps (1) through (3) for each cylinder.
  
This measurement must be done in as short a time as possible.
Compression pressure :
1,324 kPa (13.5 kgf/cm², 192 psi) / 200 ~ 250 rpm
Minimum pressure :
1,177 kPa (12.0 kgf/cm², 171 psi)
Difference between each cylinder :
100 kPa (1.0 kgf/cm², 15 psi) or less
(5)
If the cylinder compression in 1 or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat steps (1) through (3) for cylinders with low compression.
A.
If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.
B.
If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket.
6.
Reinstall spark plugs.
7.
Install ignition coils.
8.
Connect the injector extension connector and ignition coil connectors.
9.
Some DTC's may exist after the inspection test and may need to be manually cleared with GDS.
Specifications
Description Specifications Limit General Type In-line, DOHC 　 Number of cylinders 4 　 Bore ...
Troubleshooting
Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel ...
See also:

Under Body (2WD)
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

Specifications
Items Specifications Rated voltage 5V Load Max. 1mA Detection illuminations Tail lamp ON : 2.7 ± 0.05 (V) OFF : 4.3 ...

Specifications
Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 0 ~ 539.37 (0 ~ 5.5, 0 ~ 78.23) Current value(mA) ...

Manuals list

Copyright © xm.ksmanual.com 2014-2026