Kia Sorento: Illuminated ignition switch (if equipped) - Key positions (If equipped) - Driving your vehicleKia Sorento: Illuminated ignition switch (if equipped)

Kia Sorento (XM, 2011-2015) Owner's Manual / Driving your vehicle / Key positions (If equipped) / Illuminated ignition switch (if equipped)

Whenever a front door is opened, the ignition switch will illuminate for your


Whenever a front door is opened, the ignition switch will illuminate for your convenience, provided the ignition switch is not in the ON position. The light will go off immediately when the ignition switch is turned on. It will also go off after about 30 seconds when the door is closed.

Ignition switch position

Lock

The steering wheel locks to protect against theft (if equipped). The ignition


The steering wheel locks to protect against theft (if equipped). The ignition key can be removed only in the LOCK position.

When turning the ignition switch to the LOCK position, push the key inward at the ACC position and turn the key toward the LOCK position.

ACC (Accessory)

The steering wheel is unlocked and electrical accessories are operative.

✽ NOTICE

If difficulty is experienced turning the ignition switch to the ACC position, turn the key while turning the steering wheel right and left to release the tension.

On

The warning lights can be checked before the engine is started. This is the normal running position after the engine is started.

Do not leave the ignition switch ON if the engine is not running to prevent battery discharge.

Start

Turn the ignition switch to the START position to start the engine. The engine will crank until you release the key; then it returns to the ON position. The brake warning light can be checked in this position.

WARNING - Ignition switch

...
Illuminated Engine Start/Stop button Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the do...
See also:

IPM Installation
1. Install IPM(Intelligent intergrated Platform Module). 2. Connect the IPM connector. 3. Install the crash pad ...

Positive Crankcase Ventilation (PCV) Valve Removal
1. Disconnect the vapor hose (A). 2. Remove the PCV valve (B). ...

Panorama Sunroof Motor Inspection
1. Close the panorama sunroof glass and blind completely (Full close position). 2. Disconnect the negative (-) battery terminal. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0332