Kia Sorento: Installation - Fuel Tank Pressure Sensor (FTPS) - Engine Control System - Engine Control / Fuel SystemKia Sorento: Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS) / Installation

  
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
Insert the sensor in the installation hole and be careful not to damage.
1.
Install in the reverse order of removal.
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat. (Refer to Body - "Rear Seat Assem...
Injector
The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling as it exits the n...
See also:

Rear Driveshaft Components
1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot ...

Output Speed Sensor Circuit Diagram
...

Rear Wiper Motor Removal
1. Detach the rear wiper cap (A). 2. Remove the rear wiper arm & blade (A) after removing rear wiper HEX nut (B). ...

Copyright © xm.ksmanual.com 2014-2026