Kia Sorento: Power Seat Motor Inspection - Seat Electrical - Body Electrical SystemKia Sorento: Power Seat Motor Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Inspection

Power Seat Motor
1.
Disconnect the connectors for each motor.
(Refer to Body - "Front seat")

2.
With the battery connected directly to the motor terminals, check if the motors run smoothly.
3.
Reverse the connections and check that the motor turns in reverse.
4.
If there is an abnormality, replace the motors.

Component Location
1. Slide motor 2. Front height motor 3. Rear height motor 4. Lumber support motor 5. Power seat switch 6. Reclining motor 7. Reclining switch 8. Lumber support switch...
Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch....
See also:

Roof Trim Assembly Repair Procedures
Removal and Installation 1. Remove the front seat assembly. (Refer to Seat (Front) - "Front Seat Assembly") ...

Roof Trim Components
1. Headliner 2. Sunvisor 3. Assist handle 4. Assist handle mounting bracket 5. Room ramp 6. Sunvisor mounting cover ...

Curtain Airbag (CAB) Module Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0574