Kia Sorento: Rear Blower Resister Inspection - Rear Air Conditioner - Heating,Ventilation And Air ConditioningKia Sorento: Rear Blower Resister Inspection

Kia Sorento (XM, 2011-2015) Service Manual / Heating,Ventilation And Air Conditioning / Rear Air Conditioner / Rear Blower Resister Inspection

1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)

Rear Blower Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recover/recycling/charging station. 3. ...
Rear Blower Resister Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the rear luggage side trim. (Refer to Body - "Interior Trim") ...
See also:

Release Residual Pressure in Fuel Line
   Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off th ...

Temperature Control Actuator Replacement
[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's si ...

Circuit Diagram
...

Copyright © xm.ksmanual.com 2014-2026 - 0.0545