Kia Sorento: Alternator Installation - Charging System - Engine Electrical SystemKia Sorento: Alternator Installation

Kia Sorento (XM, 2011-2015) Service Manual / Engine Electrical System / Charging System / Alternator Installation

1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical System - "Drive Belt")

Alternator installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Alternator Removal
1. Disconnect the battery negative terminal. 2. Disconnect the air compressor connector (A) and the alternator connector (B), and remove the cable fro...
Alternator Disassembly
1. Remove the alternator cover (A) using a screw driver after loosening the nuts (B). 2. Remove the slip ring guide (A) and then loosen the mo...
See also:

Panorama Sunroof Replacement
Movable Glass Replacement 1. Tilt the rear part of the movable glass (A) using the panorama sunroof switch. 2. Remove both side ...

Knock Sensor (KS)
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Seat Belt Reminder Removal and Installation
Removal Seat Belt Buckle Front Seat Belt Buckle 1. Remove the front seat ...

Copyright © xm.ksmanual.com 2014-2026 - 0.0519